The Introduction of symons cone crusher
Hammer mill is a good equipment for replacing roller press on the market. It is used in cement clinker grinding and ultra-fine crushing operation circuit for a long time..
The Introduction of symons cone crusher
Hammer mill is a good equipment for replacing roller press on the market. It is used in cement clinker grinding and ultra-fine crushing operation circuit for a long time. It is used in the ultra-fine crushing operation before the ball mill. The mill process has completely reached the roller press. Grinding requirements, cost is greatly reduced, greatly improving ball mill efficiency and investment costs, and has been successfully used in many cement and mining enterprises.
Hammer Mill Performance characteristics
1. It is used for the ultra-fine crushing operation before the ball mill, which greatly improves the efficiency of the ball mill and is the main equipment for sand making.
2. The equipment investment is equivalent to 10~15% of the roller press, and the mill output is increased by 40%.
3, the system process is simple, easy to operate, low maintenance costs, low failure rate
4, small footprint
Unique advantages1. The special full screen sieve plate structure design makes the same quilting discharge area double the traditional sieve plate
2. The hammer head specially developed for hammer mill adopts composite material with high hardness and high toughness, which can meet the wear resistance requirements under high speed.
The Working prinpicle of symons cone crusher
The working principle of the hammer mill:
When the rotor of the hammer mill rotates at a high speed, the hammer becomes radiated due to the centrifugal force. The rubber material enters the machine after being rolled by the feeding roller, and is immediately broken into particles by the impulse and tearing action of the hammer. The granule glue is discharged from the sieve hole in the bottom of the machine. Block, leaving the hammer to impact again until it passes through the mesh. The hammer mill does not rely on the entire energy of the rotor component to break the rubber compound, but mainly relies on the work of the kinetic energy of the hammer to complete the crushing of the rubber compound.
Type |
capacity(t/h) |
power(kw) |
CVIC515 |
5-15 |
4p 30kw |
CVIC130 |
10-30 |
4p 55kw |
CVIC260 |
20-60 |
6p 90kw |
CVIC380 |
30-80 |
8p 110kw |
CVIC410 |
40-100 |
8p 160kw |